The old wonky joystick had no electronics so i decided to make a VR cyclic controller for The Rift S. The first picture shows it just held in foam on a stick. This worked quite well but I thought I could use my old Hotas Base with four post to act as the pivot point and also the spring holder or in this case rubber bands. It does also show that I could mount this as a damper support if the project works out. Any old joystick base would do and then the rest is plumbers materials. I still have to find a good way of mounting the Rift S controller to the front position. then the hard part is getting the controller latched on and the putting it in the holder without moving the cyclic stick in VR. but I think I have the answer to that, but we will have to wait and see.